# Is there really an elastic deformation

The definition and description of the terms force, tension, elastic / plastic deformation etc. belong more to the area of ​​strength theory or mechanics. Since the topic is very closely linked to the field of materials technology, the most important basic knowledge is explained in this script.

### tension

First of all, the term voltage should be explained:
In mechanical engineering, components are usually exposed to mechanical stress, i.e. a force or torque. These forces create stresses in the component (or in the material). Tension means that a certain force acts on a certain area.

The mechanical stress is thus defined as the force per area: δ = F / A

This means that if, for example, a force acts on a large area, the resulting tension is low. But when the force acts on a small area, the tension is comparatively great.

### deformation

Since materials are not completely rigid, they are deformed under the action of stress. The deformation of a workpiece can occur, for example, in the form of compression, expansion, bending, twisting, etc. It always depends on the type of mechanical load how a component deforms.
As is known, the various materials can be deformed with varying degrees of difficulty or ease. And materials can react differently to loads.

For mechanical engineering and especially in the field of materials technology, it is very important to distinguish between elastic and plastic deformation. The following is the most important information about these two types of deformation.

### Elastic deformation

We speak of elastic deformation when a material or a component returns to its original state after a load. This means that the elastic deformation persists over the time in which a corresponding load acts.
As long as the load is not great enough to cause atomic migration, it remains a purely elastic deformation. The lattice of the metal is deformed (e.g. compressed, stretched, etc.), but then all atoms move back to their original position. Components should only be loaded to such an extent that there is elastic deformation. Hooke's law describes how to calculate the deformation under a load.

In the following picture the process of elastic deformation is shown again schematically.

### Plastic deformation

If the loads and the resulting stresses in the component are too great, plastic deformation of the material or metal occurs. With plastic deformation, a component does not return 100% to its original shape - this is also referred to as a change in shape. Part of the deformation is still elastic and therefore reversible, only a certain part is plastic and remains permanent. If the force acting on the component is too great, in extreme cases it can also be destroyed (e.g. break).
In mechanical engineering, components should not be so stressed that plastic deformation occurs.

In the following picture the process of plastic deformation is shown again schematically.